Data

 

 

ECA 500

Sani Powder

Residential and Commercial Sanitizer

ACTIVE INGREDIENT:

Sodium dichloroisocyanurate dihydrate........................   99.0%

OTHER INGREDIENTS:...............................................    1.0%

TOTAL: ...................................................................... 100.0%

Provides 55% Available Chlorine

KEEP OUT OF REACH OF CHILDREN

DANGER                     

FIRST AID

IF IN EYES: Hold eye open and rinse slowly and gently with water for 15-20 minutes; Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye; Call a poison control center or doctor for treatment advice.

 

IF ON SKIN OR CLOTHING: Take off contaminated clothing; Rinse skin immediately with plenty of water for 15-20 minutes; Call a poison control center or doctor for further treatment advice.

 

IF SWALLOWED: Call a poison control center or doctor immediately for treatment advice; Do not induce vomiting unless told to do so by a poison control center or doctor; Have person sip a glass of water if able to swallow; Do not give anything to an unconscious person.

 

IF INHALED: Move person to fresh air; If person is not breathing, call 911 or an ambulance, then give artificial respiration, preferably by mouth-to-mouth if possible; Call a poison control center or doctor for further treatment advice.

Have the product container or label with you when calling poison control center or doctor or going for treatment. In case of emergency, call poison control center at 1-800-222-1222 for treatment advice.

NOTE TO PHYSICIAN: Probable mucosal damage may contraindicate the use of gastric lavage.

 

PRECAUTIONARY STATEMENTS

HAZARDS TO HUMANS AND DOMESTIC ANIMALS

DANGER.  CORROSIVE: 

Causes irreversible eye damage and skin burns. Harmful if swallowed. Avoid breathing dust and fumes. Irritating to nose and throat. Do not get in eyes, on skin or clothing. Wear protective eyewear (safety glasses or goggles). Wear protective clothing and rubber gloves when handling this product.  Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco, or using the toilet. Remove and wash contaminated clothing before reuse.

ENVIRONMENTAL HAZARDS

This pesticide is toxic to fish and aquatic organisms.

PHYSICAL OR CHEMICAL HAZARDS

Strong oxidizing agent. Contact with water slowly liberates irritating and hazardous chlorine containing gases. Decomposes at temperatures above 464°F with liberation of harmful gases. When ignited, will bum with the evolution of chlorine and equally toxic gases.

Never add water to product. Always add product to large quantities of water.  Use clean, dry utensils. Do not add this product to any dispensing device containing remnants of any other product. Such use may cause a violent reaction leading to fire or explosion. Contamination with moisture, organic material, or other chemicals may start a chemical reaction with generation of heat, liberation of hazardous gases, and possible fire and explosion.

IN CASE OF FIRE OR SMOKE: Call the fire department. Do not attempt to extinguish the fire without a self-contained breathing apparatus (SCBA). Do not let the fire burn. Flood with copious amounts of water. Do not use ABC or other dry chemical extinguishers since there is the potential for a violent reaction.

IN CASE OF CONTAMINATION OR DECOMPOSITION: Do not reseal container. Follow disposal instructions on label.

DIRECTIONS FOR USE

It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

This product may be used in accordance with the directions for use as a microbiocide/microbiostat, disinfectant, sanitizer, fungicide and algaecide in the following use sites: aquatic non-food industrial, aquatic non-food residential, indoor food, indoor non-food, indoor medical, and indoor residential.

HARD SURFACE SANITIZATION

This product is recommended for use as a hard surface sanitizer on household/domestic dwellings indoor premises, residential floors, laundry (household and coin operated), toilet bowls (interior surfaces),

bathroom premises/hard surfaces, refuse/solid waste containers (garbage cans)

SOLUTION PREPARATION -Prepare a 500 ppm (mg/L) sanitizing solution by thoroughly mixing 1 oz. of this product with 10 gallons of water (4 grams per US Gallon) (1 gram per US quart).

Solutions containing an initial concentration of 500 ppm (mg/L) available chlorine must be tested with a suitable chlorine test kit and adjusted periodically to ensure that the available chlorine does not drop below 50 ppm (mg/L).

Should the available chlorine level drop below 50 ppm (mg/L), either discard the solution or add 0.1 ounce of this product per 10 gallons of water (75 milligrams per liter) to increase the available chlorine level 50 ppm (mg/L) and maintain the 500 ppm (mg/L) solution strength.

RINSE OR SPRAY METHOD - Clean equipment surfaces in the normal manner and rinse with potable water. It may be necessary to remove gross filth and heavy soil from surfaces by a pre-scrape, pre-flush, and where necessary, a pre-soak treatment. Prior to use, rinse all surfaces thoroughly with the sanitizing solution, maintaining contact with the sanitizer for at least 2 minutes. Do not rinse equipment with water after treatment and do not soak equipment overnight. The same solution may be used in the feed tanks of spray type machines providing at least one-minute contact time to sanitize equipment.

IMMERSION METHOD - Clean equipment in the normal manner. Prior to use, immerse equipment in the sanitizing solution for at least 2 minutes and allow the sanitizer to drain. Do not rinse equipment with water after treatment and do not soak equipment overnight.                                                         

INDOOR NON-FOOD:                  

SANITIZATION OF NON-POROUS NON-FOOD CONTACT SURFACES

This product is recommended for use in eating establishments, food handling and serving areas (non­food contact), commercial/institutional/industrial premises/equipment, laundry (commercial).

SOLUTION PREPARATION- Prepare a 100 ppm (mg/L) sanitizing solution by thoroughly mixing 0.2 oz. of this product with 10 gallons of water (0.15 gram per liter). Solutions containing an initial concentration of 100 ppm {mg/L) available chlorine must be tested with a suitable chlorine test kit and adjusted periodically to ensure that the available chlorine does not drop below 50 ppm (mg/L). Should the available chlorine level drop below 50 ppm (mg/L), either discard the solution or add 0.1 ounce of this product per 10 gallons of water (75 milligrams  per liter) to increase the available chlorine level 50 ppm (mg/L) and maintain the 100 ppm (mg/L) solution  strength.

RINSE OR SPRAY METHOD - Clean equipment surfaces in the normal manner and rinse with potable water. It may be necessary to remove gross filth and heavy soil from surfaces by a pre-scrape, pre-flush, and where necessary, a pre-soak treatment. Prior to use, rinse all surfaces thoroughly with the sanitizing solution, maintaining contact with the sanitizer for 2 to 5 minutes. Do not rinse equipment with water after treatment. The same solution may be used in the feed tanks of spray type machines providing at least one-minute contact time to sanitize equipment.

IMMERSION METHOD - Clean equipment in the normal manner. Prior to use, immerse equipment in the sanitizing solution for at least 2 minutes and allow the sanitizer to drain.  Do not rinse equipment with water after treatment and do not soak equipment overnight.

INDOOR RESIDENTIAL:  

HARD SURFACE SANITIZATION

This product is recommended for use as a hard surface sanitizer on household/domestic dwellings indoor premises, residential floors, laundry (household and coin operated), toilet bowls (interior surfaces), bathroom premises/hard surfaces, refuse/solid waste containers (garbage cans).

SOLUTION PREPARATION -Prepare a 100 ppm (mg/L) sanitizing solution by thoroughly mixing 0.2 oz. of this product with 10 gallons of water (0.15 gram per liter). Solutions containing an initial concentration of 100 ppm (mg/L) available chlorine must be tested with a suitable chlorine test kit and adjusted periodically to ensure that the available chlorine does not drop below 50 ppm (mg/L). Should the available chlorine level drop below 50 ppm (mg/L), either discard the solution or add 0.1 ounce of this product per 10 gallons of water (75 milligrams  per liter) to increase the available chlorine level 50 ppm (mg/L) and maintain the 100 ppm (mg/L) solution strength.

RINSE OR SPRAY METHOD - Clean equipment surfaces in the normal manner and rinse with potable water. It may be necessary to remove gross filth and heavy soil from surfaces by a pre-scrape, pre-flush, and where necessary, a pre-soak treatment. Prior to use, rinse all surfaces thoroughly with the sanitizing solution, maintaining contact with the sanitizer for at least 2 minutes. Do not rinse equipment with water after treatment and do not soak equipment overnight. The same solution may be used in the feed tanks of spray type machines providing at least one-minute contact time to sanitize equipment.

IMMERSION METHOD - Clean equipment in the normal manner. Prior to use, immerse equipment in the sanitizing solution for at least 2 minutes and allow the sanitizer to drain. Do not rinse equipment with water after treatment and do not soak equipment overnight.

STORAGE AND DISPOSAL

Do not contaminate water, food or feed by storage or disposal.

STORAGE: Keep material dry and in a dry area. Store in original container where temperatures do not exceed 125°F (52°C) for 24 hours. Keep container tightly closed.

PESTICIDE DISPOSAL: Pesticide wastes are toxic. Improper disposal of excess pesticide, spray mixture,  is a violation of Federal Law. If these wastes cannot be disposed of by use according to label instructions, contact your State Pesticide or Environmental Control Agency, or the Hazardous Waste representative at the nearest EPA Regional Office for guidance.  The preferred disposal methods are incineration or chemical treatment in accordance with Federal, State and Local regulations.

DO NOT put product, spilled product, or filled or partially filled containers into the trash or waste compactor. Contact with incompatible materials could cause a reaction and fire. DO NOT transport wet or damp material.

CONTAINER HANDLING: Nonrefillable container. Do not reuse or refill this container. Triple rinse container (or equivalent) promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank. Fill the container ¼ full of water and recap. Shake for 10 seconds. Pour sate into application equipment or a mix tank or store in sate for later disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Then offer for recycling if available or puncture and dispose of in a

MFR: 041916   AK: 031720

Granule Product effective for 2 years from date of production when properly stored.

SEE SIDE PANELS FOR ADDITIONAL PRECAUTIONARY STATEMENTS AND DIRECTIONS FOR USE    

EPA Reg. No.: 91138-1                                         

EPA Est. No.: 86542-NJ-001

ECA Water Systems

115 Dansworth Lane

Oak Ridge, TN 37830